![]() ![]() I wonder what these nvram settings do at boot, I guess the CFE is using these to initialize the board so maybe this extra setting is wrong for AC68U.Īnother experiment would be to unset the 1:ledbh6=136 on dd wrt and save nvram and reboot, as it was added in the patchset 22502 by BS, and see what happens but I'm not quite sure if that could boot loop or brick the device, for sure it will be re-set by the dd wrt initialization, so maybe someone with a spare AC68U or a spare amount of courage can try it and see if the 5 GHz led comes to life at least for the first boot right after having unset it (the ledbh10 setting is correct and done also in merlin so that should work as it is the only relevant setting of 5 GHz led in merlin). In the dd wrt code I see that the AC68 is identified as AC67 but I'm not quite sure this is correct, at least for the 1:ledbh6=136 initialization which is done for AC67. I believe it can also be an original asus wrt as I think the nvram settings are the same as merlin wrt. Now to confirm this I need someone with the merlin wrt which has, as far as I know, the 5 GHz led working to run the same nvram show command, so to extract the ledbh initializations from the nvram from a wrt with 5 GHz led working. ![]() In merlin firmware the initialization don't set apparently for the AC68U the ledbh6 nvram parameter. What I found till now is that it 'seems' that the initialization is correct, but there's a slight deviation which I cannot explain which nvram show |grep ledbh I am investigating the issue in trac about the 5 GHz led not working on the RT-AC68U. Posted: Sat 11:42 Post subject: RT-AC68U 5 GHz led not working: info needed ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |